Product Categories

Sonifex D-20F1ONA

Flush Mounting  ‘ON AIR’ Sign

The SignalLED range of illuminated RGB LED signs are a new range of signs designed for outside recording, on-air & production studios, meeting rooms, conference rooms and for fixed installations. The sign itself contains the control electronics, and RGB LEDs are used, so the signs can be simply configured onsite for your particular requirements.

RGB LEDs - Any Colours Possible

The illuminating LEDs in the unit are RGB meaning that the colour of the sign can be selected on installation. You can configure the sign from one of 8 colours: white, green, red, blue, yellow, orange, cyan and magenta. 

Dual Control Inputs

The sign can be controlled by either, or both, of 2 pull-low inputs, e.g. a single input can be used to control a single ‘MIC LIVE’ sign, or 2 inputs can be used to control a twin ‘TX’ and ‘REH’ sign with independent control of each side of the sign.

Different Display Modes

Four modes of illumination are available:

  • Constant illumination.
  • Flashing, regularly on/off.
  • Pulsing - flashing, then off, repeated
  • Off

Single or Twin Signs

Each sign is 40cm or 20cm long. The 40cm signs can be split into two 20cm sides which can be separately, or jointly controlled, e.g. you can have a 40cm ‘ON AIR’ sign, or twin 2 x 20cm signs, such as ‘ON AIR’ and ‘MIC LIVE’.

Flush or End Mounting

The sign is supplied as standard so that it can be mounted flush to a wall, e.g. for the ‘TX’ & ‘REH’ sign shown. However, a mounting kit is available, LD-KE1, to mount the sign perpendicular to a wall, e.g. above a door, such as the ON AIR sign shown.

Single 20cm Flush Mounting Sign

These are the available choices for the smaller 20cm flush-mounting signs. Custom signs can be made to order, if required

Simple Installation

The signs are supplied with a 6V wall-wart power supply with international adapters for the UK, Europe, USA and Australasia & a 5m lead. Simply wire up your control signal(s) and DC input to the ‘screw terminal block’ inside the sign, route the cables through the integral cable clamp and mount the unit on the wall.

An installation tool, the LD-IT can be used to hold the sign in place on the wall mount whilst you wire it up. The display mode and colour options are set-up using the optional Remote control unit ( additional charge)

PRICE EXL VAT: 150,00 €
logo footer

KEM Systems Ltd
All rights reserved © 2013
Design & Implemented Site: ClickMedia

MONDAY / FRIDAY 09.30 - 19.00
4 Krimeas str. Ampelokipi 11526
210 - 67 48 514
This email address is being protected from spambots. You need JavaScript enabled to view it.